For this project - (I have coined this type of wordbook in my previous post as Type 1- where the basic frame has the same dimension throughout.) I used thin weight chipboard which I ripped from DCWV stack. But the approx thickness is equivalent to cereal box and is around .022 inches. Single cut with regular blade and housing. After I cut the extra letters b,a,b,y (2 sizes reduced from the welded original), I versamarked it and embossed it with Zing powder (Buttercup I think). I then added some ribbons on the book ring and on the pages a cute stroller ribbon which I picked up at Michaels. On the front page I made a small frame by using Paisley Nestability. For the wheel I didn't have a scalloped punch but had a punch from the Imaginisce brad maker, so I just punched a pattern paper and layered the wheel. Later I will pick up some co-ordinating plain card stock and cut just the stroller and add it in between the chipboard pages and further add more embellishments and also finish inking the edges.
Here are the pictures of the wordbook
And here are the videos .
